The outdoor WCP is an IP67 sealed manual call point product. The enhanced environmental protection allows the unit to be installed in many external environments where water and dirt are likely to be present, making it a true waterproof and outdoor product.

Installation time and ultimately cost, are of paramount importance to any fire or security installer. The WCP range directly reflects this need by providing a unique ‘plug and play’ concept designed specifically to reduce installation time. All new WCP products utilise a special terminal block, where all initial installation cabling is terminated. This terminal block is then simply connected to the back of the WCP. Simple, but effective with no re-termination required and no time wasted. In addition, all WCP products are supplied with three standard 20mm threaded cable entries, accommodating all types of surface wiring installations.

All WCP Outdoor Call Point products also help preserve the integrity of the overall system as illegal removal of the product lid will result in the call point operating and the system going in to alarm.

The WCP1A product version is supplied with both a resistor and normally open clean contact electrical options. These options are easily utilised by simply connecting the terminal block to the required connection in the back of the WCP1 product. A variety of resistor versions are available, with both 470W and 680W offered as standard. However, other resistor types can be provided upon request.

The WCP1A-R470IS is  red waterproof Intrinsically Safe resettable call point.  KAC offer an unparalleled range of indoor and outdoor, break glass, re-settable and key operated call points.

The latest WCP ranges have dual connection options with the use of the patented ‘plug & play’ terminal block concept. After wiring the terminal connector, plug into the appropriate position.

1A & 1B models are supplied with a 470Ohm resistor fitted in series but can also be connected without the resistor (short cct). They have a Single Pole changeover contact, rated at 30vdc.

• sealed to IP67;
• unique ‘Plug & Play’ installation concept;
• total ‘Flex-Ability’ in the choice of operating element;
• anti-Tamper facility;
• resettable;
• enhanced aesthetics and compact design;
• fully approved to the latest standards;
• CPD Approved;
• with plastic element.

You can find the product by unique code: WCP1A-R470IS.